Painting Walls & Ceilings

Painting Walls & Ceilings

Painting walls and ceiling 2Painting is a project that works best if you have a painting partner. One of you can be the outliner, the other the roller.  The outliner uses a brush to cut in, or outline, all the areas a paint roller can’t reach. The roller spreads paint. If you’re painting solo, you get to change hats by switching tools and performing both tasks.  If you’re painting with a partner, give the outliner a head start to paint a two-inch band along the joint between the ceiling and the wall.

The outliner observes the top down rule, which means he should first paint the ceiling molding (if there is any), and then outline a band of paint on the ceiling and wall if you’re painting the same color. You don’t want the outliner to get too far ahead at the roller, or you lose the wet edge and end up with lap marks.

If you’re the outliner you should next cut in a band of paint around any areas the roller can’t reach, like around light fixtures or radiators. You also want to paint around light switches and electrical outlets.

Looking for color ideas for your painting project? Check out these great tips and ideas from HGTV.

After the outliner cuts in around the edges the ruler can begin on the ceiling, working from the corner outward into the room parallel with the longest wall.  If you’re the roller work your way across the ceiling in three or four foot square patches, and when you reach the opposite wall go back to the first wall.

painting walls and ceilings with 2 peopleAs the outliner, once you finish cutting in around the edges you’re ready to outline the corners have all the walls laying on a two-inch wide flow of paint from the top of the corner down the walls.

Next cut in a band of paint around all windows and doors. Don’t forget, if you’re rolling the paint be sure to keep up with the outliner so the paint doesn’t dry because the rolled on paint acts like a second coat over the dry cut-in paint.

Finish up the outlining at the base boards around the floor. For these straight areas, use a trim guard or painters tape to keeping off the baseboard and surrounding areas.  The outline or starts first and ends first. Of course the outliner could pick up another roller and help finish the job.

Comments are closed.