delete
New Kitchen Faucet Installation – Part 2

New Kitchen Faucet Installation – ...

We’re just picking up where we left off in our first part of this kitchen faucet installation. If you missed it, you can get caught up by going here for part 1. Now we’re going to get down below and try to do a few things under the sink for the actual hook up. Okay so here we are underneath our sink, you can see we’ve got our drain pipe and our water lines and everything. There is quite a bit going on under there but as we just kind of zoom in underneath there, I’m going to try to get a shot of the bottom side where the faucet comes through the counter top. It’s going to...
delete
Installing a Kitchen Faucet

Installing a Kitchen Faucet

Today we’re going to have a look at how to install a kitchen faucet. So we’ve actually already installed the actual faucet that we’re using here but I’ve purchased a very similar one just so we can show you the basics of what you’re going to go through to put it in with the small cabinet under this particular sink. It’s pretty hard to get down there to show you very much. So one of the main things is you’re going to have a few choices, you could have a faucet such as this one that has a single lever of some sort, it could be on the side, it could be on the back whatever....
delete
Build Your Own Gate – part 2

Build Your Own Gate – part 2

Putting up a gate – at least writing about putting up a gate – take a while. I figured it would be easier for you to digest in 2 parts, so I split it up. If you want to go back and read the first part, just click here for part 1. Ok so just getting that hinge straight, I actually should have a bigger driver. Let’s see if I can make this one work. Ok this hole here is really close to the edge of the picket so I am just going to leave that one out for now, if I need it, I will pre drill that hole and try to get one in there without splitting, okay I’ve got this in place now...
delete
Building a Gate

Building a Gate

Today I want to discuss with you how I would build a gate for a fence. We have already built the fence and as far as the gate goes, I have already pre fabed the main framework to the gate just to speed up time. So you can see I have constructed it out of two by four framing. So I built my outside framework and I used construction adhesive and screws to hold it together, I then put in an angled cross brace which will help support this far end from sagging. The right hand end will be the end that’s hinged and it’s going to go right over in this opening right here. So this...